Step 1: Drill a hole on the bottom of the planter that is 1-1/4 in. wide using the 1-1/4 in. Drill Bit.
TIP: Wear safety glasses when operating an electric tool.
Step 2: Position the planter and make sure it is level.
Step 3: Place 5 pavers into the planter depending on the desired height of your water feature.
Step 4: Assemble the TotalPond® Container Fountain Kit with Light and place it on the pavers. Run the cord down the planter and out the hole in the back.
Step 5: Mix the two part epoxy (included in the kit) until it is a consistent gray color. We recommend wearing gloves. Use the epoxy to fill the hole that the cord is running through. Be sure to have enough slack in the cord so you can position the pump in the center of the planter. Wait a minimum of 1.5 hours or more for the epoxy to harden.
TIP: Do not move the cord while the epoxy is setting.
Step 6: Test your epoxy by adding water to test the seal. if you do not see a leak, then begin to fill the area around the pavers with lava rock. Leave about 6 inches at the top for the decorative pebbles.
TIP: Rinse the lava rock before placing in the planter. Your water will become red if you do not.
Step 7: Add pebbles and fill with water. Once the pump is fully submerged, plug and enjoy!